1. FILL & INJECT
Use the finger wings to load the syringe and inject the patient. This will prevent the needle from sealing early.
2. SLIDE SEAL
Hold the containment tube in place and slide the plunger through until it clicks to seal the used needle and lock it into place. Discard appropriately
1. PLUNG FULLY
Insert the plunger fully to collapse the needle in.
2. PULL OUT
Pull the plunger fully back to bring the used needle inside the syringe and lock into place.
3. BREAK PLUNGER
Snap the plunger to ensure the used needle does not release during disposal. Discard appropriately
1. LOAD SYRINGE
Pull the plunger back and load the syringe as you would with a standard syringe.
Carefully push the plunger forward to inject the patient.
Simple snap the attached cap to seal the used needle. Make sure it clicks into place. Discard appropriately